JX-PIC100

PIC24/dsPIC33 Microcontroller Experiment board

• Support PIC24 and dsPIC33 in TQFP-100 pin package by using the microcontroller adaptor module. The default module is PIC24FJ128GA010. It is plug into the femal header on the main experiment board

• Program and Debug with PX-200 USB programmer board or Microchip's PICkit2 and ICD2 (sold separated)

• Automatic program and run by software

• On-chip clock generator and 32.768kHz crystal for on-chip Real-time clock module

• Supply voltage range is +6 to +9V. On-board +5V and +3.3V  regulator circuit

• 50 free pins port. It includes :

  • Port A - 4 pins (RA9, RA10, RA14 and RA15)

  • Port B - 12 pins (RB0 to RB4, RB8 to RB14)

  • Port C - 4 pins ง (RC1 to RC4)

  • Port D - 12 pins (RD0 to RD3, RD6 to RD13)

  • Port E - 2 pins (RE8 and RE9)

  • Port F - 5 pins (RF0, RF4, RF5, RF12 and RF13)

  • Port G - 11 pins (RG0, RG2, RG3, RG6, RG7, RG8, RG9, RG12 to RG15)

  • +5V, 3.3V and GND female header            

  • RESET switch available

  • 8-LED with limit current resistor. Active at logic �0� and connect with RA0 to RA7 pin.

  • 4 of Button switch with pull-up resistor. They are connected with RE0 to RE3 pins.

  • Full duplex RS-232 serial port circuit

  • On-board +3.3V Character LCD with LED back light

  • 4 of 0 to +3.3V Variable voltage sources for A/D converter experiment

  • SD card interfacing circuit

  • Includes :          JX-PIC100 board, PIC24 microcontroller adapter module, CX-232 Serial port cable,  and Technical leaflet